Method To Take Measurement From the Customer - 2
                                          DIRECT BODY MEASUREMENT

    5. SLEEVE LENGTH

                 Hand height should be taken from the solder sleeve edge to their sleeve height requirement. 

    6. SLEEVE ROUND 

  Hand loose should be taken from the customers where their sleeve height ends.       Don't leave any loose. EXAMPLE = 12”

        Take The Sleeve Loose as Per the Customer’s Measurement For Ordinary Blouses,                     

For  Model Sleeves Like Cap Sleeve And Petal Sleeve Sleeve Round, Loose Can Extend By .5 Inch.

7.  MIDDLE HAND LOOSE

  This measurement should be taken in the customers middle hand part without leaving any loose. EXAMPLE = 12”, take The Customer Measurement As Per The Middle Hand Loose. This Middle Hand Loose Should Not Less From The Sleeve Round, And Should Not Exceed From Above 1.5 Inch From Sleeve Loose. The Both Measurement Can Be Equal Also.

8. FRONT NECK HEIGHT (DEPTH)

This should be taken from the front side. The neck deep minimum should be 1/2 “down from their body armhole line. The tape should not take by cross; it should be straight.

EXAMPLE = armhole 5 ½ + ½” = Total 6” Minimum neck height should be 6”.

Please Check the Front Neck Height Measurement with Customer’s Center Chest Measurement, 

For Body Loose 26-30 = Front Neck Height 5.5 Inch

For Body Loose 31-36 = Front Neck Height 5.75Inch; 

For Body Loose 37-38 = Front Neck Height 6 Inch; For Body Loose 39-43 = Front Neck Height 6.50 Inch; For Body Loose 44-49 = Front Neck Height 6.75 Inch.

Measurement Can Increase Or Decrease From .50 Inch From The Above Measurements. If This Measurement Exceeds From The Above Rule, The Neck Width Will Be Less, So The Blouse Will Not Set Perfect.

9.  BACK NECK HEIGHT (DEPTH)

     This should be taken from the back side. The neck deep minimum should be ½” down from their body armhole line. The tape should not taken by cross, it should be straight. Back Neck Height Can Be Down From Minimum .5 Inch From The Front Neck Height. The

Measurements Can Be Changed according To the Customer’s Choice.

EXAMPLE = armhole 5 ½” + ½ = Total 6” Minimum neck height should be 6”.

10.WAIST LOOSE (ROUND)

             This should be taken from the front side where the last hook will be hanging. This measurement should be taken very tightly with the customer. While taking this measurement, Customer will tell no need of this much tight but for perfect blouse the measurement should be taken like this tight only. EXAMPLE = 29” Waist Loose Can Be Less From 4 Inch Upto 10 Inch From The Body Loose Measurement.

Example – Body Loose-40= Hip Loose May Be = 36-30, Hip Loose Should Not Be 29 To 37.

 11.   FRONT DART POINT

       This measurement should be taken from the front side from the top of the shoulder to their front point center, this measurement should be very accurate.   EXAMPLE = 9”.

If The Customer’s Blouse Leaves The Point Center Sharp, Less The Front Point Center Height Or If The Customer Does Not Require Sharp, Less The Front Dot Height Measurement By 1”. 

While Taking Measurement if Customer in Kameez Top Dress,                                                    then Less This Front Dart Point by .5 inch to 1 Inch, as per the Customer Measurement.

 12. FULL SHOULDER

                   This measurement should be taken from the Back side from the left side Shoulder Bone to Right Side Shoulder Bone, this measurement should be very accurate. EXAMPLE = 14.5”.

13.    ARM ROUND

                            This Measurement should Be Taken from the Arm Circumference of The Customer, While Entering Middle Hand Loose automatically the Arm Round Will Appear.