Method To Take Measurement From the Customer - 1
                           DIRECT BODY MEASUREMENT

1. LENGTH

         This measurement should be taken from the customer at the back side. First correct the customer blouse without any wrinkles now take the measurement from the shoulder top to their blouse. Height don't leave any folding cap for stitching gap height = 13”.

   

    While Taking Measurement, Extend The Height From Min 1inch To 1.5 Inch From Their Brasier Height. The Average Height For The Customers Will Be From 12inch To 14.5 Inches, Based Upon The Customer Height. If The Customer Height Exceeds From 14.5 Inch, The Front Patti Height Will Be Large, Then The Patti Will Bound To The Customers Stomach, So The Patti Will Be Fold, So Please Check With The Above Measurement.

 

2. UPPER CHEST

This should be taken from the customer's upper part of the chest, Under the arm. No loose should be leave on the tape, check the back side that tape is not in crosses. Take the measurement as round number like 32, 33, and 34. The measurement should not like ¼ ½ ¾. If we take Measurement Directly, Mostly will be Equal to Center Chest or Less From Center Chest, Will not Exceed the Center Chest. If Not taken can Be Equal to Center Chest or Less one Inch from Center Chest.

 

3.  CENTER CHEST

This should be taken from the customer's Center part of the chest. At the Dart Center Point. No loose should be leave on the tape, check the back side that tape is not in crosses. Take the measurement as round number like 32, 33, and 34.  The measurement should not like ¼ ½ ¾.

Don’t Let Loose In The Center Chest While Taking The Measurement, Less One Inch For Withour Lining Blouse. For Example - Actual Center Chest - For Ordinary Blouse (Without Lining) -30inch - 24 Hours Blouse, For Lining Blouse - 31 Inch.

 

4.  SHOULDER FINISHING

This should be taken from the customers blouse from the sleeve joint part to the next side finishing. This measurement will be like 2, 2 ¼, 2 ½. EXAMPLE = 2 ½”

Check The Below Measurements By Using The Customer Body Measurement. 

Customer  Shoulder Finishing Measurement Can Be Plus Or Minus 0.25 Inch From The Below Measurement. For Body Loose 26-30 = Shoulder Finishing 1.5 Inch

For Body Loose 31-36 = Shoulder Finishing 1.75 Inch; For Body Loose 37-38= Shoulder Finishing 2 Inch;

For Body Loose 39-43= Shoulder Finishing 2.25 Inch; For Body Loose 44-49= Shoulder Finishing 2.5 Inch.

Measurement Can Increase Or Decrease From .25 Inch From The Above Measurements. If This Measurement Exceeds From The Above Rule, The Neck Width Will Be Less, So The Blouse Will Not Set Perfect.